Hi, I’ve been trying to use a series of three attractor curves on the outline of a trimmed surface to create a sharp dip down then a slow return back to the original surface height on several edges. The attractor curves seem to be working but the surface from points isn’t working from this trimmed …

This doesn’t look complicated at all. [trimmed surface_2023Jun20a] trimmed surface_2023Jun20a.gh (211.8 KB) If you want a hole in the final surface, just add it to Project.

Complicated trimmed surface and use of attractor curve on edges

Grasshopper

Joseph_Oster June 26, 2023, 6:59am 14

Here are a few search results that might be helpful? Look at all the replies in each thread, not just these.

1 Like