[quote=“gregb, post:11, topic:15926”] And I read that other thread, but am still not sure exactly what the command does incorrectly there, it seems a bit different of an issue than here.
[/quote]
ha, yeah… i found that thread too… most of it is confusing and it wasn’t til the end where the problem started to emerge.
there’s a new thread which has the same issue though:
discourse.mcneel.com/t/extrudesurfacetapered/15940/3
so i was just going to see if that one gathers any steam instead of bumping the old/confusing one.
but i think the problem isn’t related to what you’re seeing… it’s more to do with how the offset is handled incorrectly with curves (or-- possibly correct but not accurate… if it was done accurately, i think it would create a much heavier surface than what it gives now)