Circular "brick" patterns

Grasshopper
1

Revisiting an earlier step in a project to generate “bricks” instead of offsetting inward my final surface, which results in complicated and redundant geometry.

How can I trim these spokes between the outer and inner wall such that I generate a pattern of discrete closed curves? Or, is there a way to connect the points that demarcate the inner and outer wall?

24%20AM
Screen Shot 2019-06-24 at 11.02.24 AM.png1118×1038 52.8 KB

2

Something like this?

Canvas%20at%2001%3B39%3B23
Canvas%20at%2001%3B39%3B231509×662 69.9 KB

CircularPattern_re.gh (11.4 KB)

2 Likes
3

Wow, that’s right. So it seems where I stopped short was to loft from inner to outer then divide the domain up with 1 U and n V sections, then use isotrim to extract the individual surfaces created with domain divide. The curves grouping at the end extracts curve geometry from the surfaces. Is that it?

Thank you so much!