Can't show the entire generation to see paretro front & clustering result

Grasshopper Wallacei
, ,
1

HiHi this problem has confused me for a long time…

my wallacei analysis result can’t output:

the entire generation to see paretro front & clustering result

  • FO1-FO3 is my objectives, FO4-FO6 is the restrict i set(so it didn’t show the result it’s correct)
  • i have set the null value for filter the inpropreate candidates
  • and for analysis near the restrict i set, i have set penalty value(a large number, cuz my analysis i want it to find the minimize result)

image
image2382×1475 449 KB

the upper Chart is my analysis result, seems it only shows the paretro solution not the entire population(but i have press the “show entire population“ bottom)

image
image2394×1477 397 KB

And this is my wallacei selection panel, im not sure the problem should be my PCP analysis result only show one solution so i cant show the clustering or not?

im not sure what’s the bug is…

hope someone if know the concept where i didnt catch could help me to figure it out :confounded_face:

2

You should not connect FO4-FO6 to Wallacei if they are not supposed to be directing and guiding the simulation. You need to change the way you formulated your problem

3

I see thank u ~ :smiling_face_with_three_hearts:

but if i want to let the analysis result near my setting tolerance range

is there any recommend tips to input it ? :woman_raising_hand:

4

Connect the non objective data to the Data Input, get them out of Wallacei when simulation is done and use Wallacei Analytics components to plot the graphs and analysis for these values