Hello
Hey dear friends…
I would like to know how to make the attached (geometry photo) as solid !or with density for 3D printing ?
It would be appreciated if some one could help me!
Best regards
Ali
[bone like 2]
hello everyone,
I have an idea, I’ve been trying it out for a long time, but unfortunately I can’t manage it.
I hope someone can help me with that:
a bone-like structure is to be created, which is to be created with the help of stress lines and attractor.(?)
the first step i would do with tOpos, and for the inner structure i need your help
i.e. where the pressure or pull is the most, the structure should be denser, like a human bone.
I hope I’ve described it well
many thanks again to all
…
Hi @yotamcdo
One issue with taking the curves from a Voronoi diagram of random points is that it usually has some very tiny edges and sharp angles, this is what was causing those funny looking nodes.
[image]
If you run some cleanup on the lines to get rid of these it is often enough to make it work:
multipipe_fix.gh (16.3 KB)
(also uses this tool Topologizer.gha (19 KB) )
[image]
but this seems not really like your image. If you really want to make it you’ll have to work a bit more on the key characteristic of this structure. Is it open structure (a fluid can go every where) a closed cell …
1 Like