Boundary surface wrong height

uar777 · September 2, 2019, 5:27pm

Hi all
First post here. So basically I’m having a go at creating a circular pattern of tiles which change orientation coming toward the centre. I’m currently stuck as shown on the pic below that the second inner tile is sitting on ground level instead of being created from the plane of the 3D Rotate geometry.

danielbent · September 2, 2019, 5:34pm

I guess you want to make closed breps/solids out of every part? You can just extrude the curve and cap it after.

Islamic Pattern_re.gh (64.2 KB)

uar777 · September 2, 2019, 5:42pm

Almost there. I need the extrusions to be normal to the plane of each tile in each polar array.

danielbent · September 2, 2019, 6:22pm

Like this?

Islamic Pattern_re2.gh (70.9 KB)

HS_Kim · September 2, 2019, 7:09pm

Check this as well.

Islamic Pattern_re.gh (68.6 KB)

uar777 · September 2, 2019, 7:36pm

Thanks very much. Like your ideas. Your inspiring guys.