As a father, I need help

Rhino
1

Gasket1
Gasket1610Ă—362 19.3 KB

2

Where are you running into issues? What does your current file look like? Do note that you really only have to draw 1/4 of it.

" As a father, I need help" Please edit your title to be more descriptive of the issue (no one is going to be searching the forum for father issues..)

3

Is this some inside joke or did you genuinely expect someone to know what you need help with from a single picture?

6

They had duplicate posts, the other had a little more info (its his son’s homework). I don’t think its spam but keeping an eye on it.

7

well obviously someone needs help… as a father.

8

This is a lot more difficult for a beginner than it might seem

Draw 4 arcs then run the fillet command 4 times with a 1.5 radius. …

image
image1489Ă—914 10.3 KB

The real lesson a beginner needs to know is that Rhino is a minefield. If you know where the mines are buried you will become very proficient.

9

Highly descriptive post headline, akin to the classics “Can u help, plz?” or “It’s not working!”, of course with no 3D file attached.