Annotation Parameter Problem

Rhino Rhino for Windows
,
1

Hello,

I created a new Annotation Style “DAN”. I can use it just fine on the first drawing, but when I open a second or further drawing, select the “DAN” style, two parameters come up different than applied …

  1. DIMENSION TEXT have been reset from ‘Inline’ back to ‘Above Line’.
  2. LENGTH UNITS have been reset from ‘Inches Fractional’ back to ‘Model Units-Decimal’.

All other parameters for DAN are proper in any other drawing I open.

Is there some other overriding setting somewhere that influences Inline/Above line and Fraction/Decimal … or is this potentially a bug?

Here are two side by side images comparing DAN parms in CAD file 1 & 2.

Prop1
Prop11467×1124 140 KB

Prop2
Prop21497×1229 157 KB

Appreciate the assist!

B

2

I could not repeat that behavior here.
Can you send me the document where the style is set correctly (no objects need to be in the file)
Also run _SystemInfo and post back the results