Hi,
when I am trying to add a solid to a wall, the solid doesn’t take the wall hatch. But this was possible in the older versions, as far as I know, wasn’t it? Is there a way how can I handle this?
Best!
Petr!
Hi,
when I am trying to add a solid to a wall, the solid doesn’t take the wall hatch. But this was possible in the older versions, as far as I know, wasn’t it? Is there a way how can I handle this?
Best!
Petr!
Hi Petr,
I don’t think so.
But if you assign a section hatch pattern to the solid before doing the addition, it will keep the hatch, regardless of the wall section attributes.
Ok,
thanks Francesc.